A wierd streamlined thingy that might stump you.

Discussion in 'Metalware' started by Miscstuff, Nov 1, 2016.

  1. Miscstuff

    Miscstuff Sometimesgetsitright

    Bought this at auction recently and it was advertised as
    "Atomic Hood Ornament with light". Saw the ancient wiring and
    just could not resist buying it. Well, shock and horror when I
    opened it up and found a heater that looks like it's made
    with asbestos. Went into emergency mode washed hands and cleaned
    up the mess etc. When the panic subsided I took a good look at
    it and it is positively weird. Firstly there is this heater
    sitting inside a tube with a hole at the front(?) maybe.
    Then there's this weird structure on top that sits at an angle
    and may represent the letters "OAP". Is something meant
    to be shoved in the hole and when heated removed? Why is it
    streamlined? I was thinking automotive but it may be aviation.
    Something like a wingtip heater to break the ice. It is made of
    aluminium and is approximately 19cm (7.5") long by 8cm (3.2") wide
    by 13cm (5.1") high. Any ideas???????????
    cheers
    Stephen
    1.jpg 2.jpg 3.jpg 4.jpg 5.jpg 6.jpg PICT0002small.jpg
     
  2. KingofThings

    KingofThings 'Illiteracy is a terrible thing to waist' - MHH

    Possibly a heater for a carburetor ???
     
  3. gregsglass

    gregsglass Well-Known Member

    Hi,
    I would venture a guess. Perhaps a cigar lighter?
    greg
     
  4. desperate_fun

    desperate_fun Irregular Member

    I'm with Greg on this one. (Cigarette)
     
    kyratango and scoutshouse like this.
  5. Mansons2005

    Mansons2005 Nasty by Nature, Curmudgeon by Choice

    I have seen similar (though not for decades) mounted on the bridge of boats and once on the dashboard of a Rover (BEFORE they had upholstery and air conditioning!) to light cigarettes as well.
     
    kyratango and scoutshouse like this.
  6. Miscstuff

    Miscstuff Sometimesgetsitright

    Couple of problems with the cigar/cigarette theories. Firstly the heater coil is insulated (remember the asbestos) from the metal tube that pokes out the front so I doubt it would get anywhere hot enough. As a fagger I know it takes a lot of heat to light one. Usually metal has to be close to glowing before it works. Secondly the metal tube touches the aluminium so the casing would also absorb heat as well. No cigar so far gang.
    Cheers
    Stephen
     
    scoutshouse and KingofThings like this.
  7. Miscstuff

    Miscstuff Sometimesgetsitright

    Another curious problem. There doesn't seem to be anyway of mounting it. I think the hole at the back is for the wiring and there is nothing underneath to hold it. It certainly meets the requirements of a "thingy".
    Cheers
    Stephen
     
    scoutshouse and KingofThings like this.
  8. Mansons2005

    Mansons2005 Nasty by Nature, Curmudgeon by Choice

    Just a passing thought - are there any signs of paint residue on the crested connector mounted on the top? I keep seeing "letters" in the way it is formed, as in a logo such as OAP, etc.

    Back to its purpose - without some sort of fan or air propulsion mechanism I don't think it is a defroster of any kind.


    AND

    I just went back to re-read something in your original post and saw that YOU mentioned the possibility of lettering on the top - first - DOH! Second, if two persons "see" it it MUST be true. There may be a clue there, but I don't have a clue what that clue is..........



    jeeze is this reply a waste of typing time or what????????????
     
  9. Miscstuff

    Miscstuff Sometimesgetsitright

    Don't give up. This things driving me crazy too. OAP "Old Age Pensioners" association??
    Cheers
    Stephen
     
  10. anundverkaufen

    anundverkaufen Bird Feeder

  11. KingofThings

    KingofThings 'Illiteracy is a terrible thing to waist' - MHH

    With my WAG I thought there was a hole in the base possibly for sending heat down a tube to a carb. If it was mounted open side to the back then low pressure would push air down but the carb would suck its own air down anyway and 'backwards' mounting would reduce the cooling effect of moving air.
    There may have been another part or parts/clips it mounted in.
     
    scoutshouse likes this.
  12. Miscstuff

    Miscstuff Sometimesgetsitright

    There's a problem with that idea. The back end of the tube buts against a bunch of that asbestos stuff. There is no airflow route through the tube. So the way I see it when the heater lights up all the heat radiates to the wall of the container and depending on how much power the heater has will determine how hot the container gets. I'm thinking it's low power and warms up the aluminium but what for is the question. Heater for a chicken farm??

    Cheers
    Stephen
     
    scoutshouse and KingofThings like this.
  13. Miscstuff

    Miscstuff Sometimesgetsitright

    scoutshouse and KingofThings like this.
  14. Mansons2005

    Mansons2005 Nasty by Nature, Curmudgeon by Choice

    Well, even if the mystery is ever solved, I WOULD use this as a hood ornament. Mounted on a Ford F-1 truck, with the hole pointed forward and a small engraved plaque engraved "Beware of Death Ray".............take THAT Bubba...........
     
    kyratango, scoutshouse, *crs* and 3 others like this.
  15. say_it_slowly

    say_it_slowly The worst prison is a closed heart

    Are F1 trucks popular in Australia? And I wonder what the equivalent to bubba is:rolleyes:
     
    Last edited: Nov 2, 2016
  16. Mansons2005

    Mansons2005 Nasty by Nature, Curmudgeon by Choice


    You talkin' to me? Huh? You talkin' to ME? Well if you are (and I hope so!), I have to say that I have no idea..............I'm in the States these days, and have never spent more than a fortnight at any one time in Australia. I was actually channeling my Cracker past in Florida. And during THAT period of my life F-1s were not considered all that old or rare.................;););)
     
  17. KingofThings

    KingofThings 'Illiteracy is a terrible thing to waist' - MHH

    Put one of those (((Zinggggg))) whistles in it. ;)
     
    scoutshouse likes this.
  18. KingofThings

    KingofThings 'Illiteracy is a terrible thing to waist' - MHH

    Holman maybe.
     
    scoutshouse likes this.
  19. say_it_slowly

    say_it_slowly The worst prison is a closed heart

    Well you're one up on me, I've never been to Australia (though I'm currently watching Miss Fisher mysteries). I was trying to imagine this on the front of an old 1930s truck with OAP standing for Overland Australia something or Outback Australia something with a little red light on the nose end of it. Boy that's really helpful LOL! I have googled a bit but without results.
     
    scoutshouse and KingofThings like this.
  20. komokwa

    komokwa The Truth is out there...!

    early car warmer.........humm...
     
    scoutshouse and KingofThings like this.

Share This Page