Message:

<p>[QUOTE=&quot;DragonflyWink, post: 4284507, member: 111&quot;]I use a diamond hole saw - have a few sizes, but have used the 1/2&quot; at least a hundred times on everything from fine porcelain to 1/4&quot; thick pottery with only the occasional light chipping on the edge.&nbsp; Start at an angle gradually moving it down to flat against the surface, and keep a spray bottle handy to keep it wet - the item will often have a foot that makes a shallow well for a little puddle of water.&nbsp; Sorry if this isn&#039;t written well, just taking a quick break from working outside in the heat, might have affected my brain...</p><p><br /></p><p>~Cheryl</p><p><br /></p><p>edit:&nbsp; Also usually make a little masking tape template to make sure I drill the hole right where it should be (the bit can chatter a little when you first start drilling).[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in